HAM foorum

Raadioamatörismist ja kõigest haakuvast.
Tänane kuupäev 21 Nov 2017, 23:01

Kõik kellaajad on UTC + 1 tund [ DST ]




Tee uus teema Vasta teemale  [ 6 postitust ] 
Autor Sõnum
 Teema pealkiri: QRP rigi Elecraft KX3
PostitusPostitatud: 23 Mai 2011, 17:48 
Eemal
Kasutaja avatar

Liitunud: 23 Aug 2009, 20:29
Postitusi: 775
Asukoht: Taebla KO18UW
Pole paha!
http://youtu.be/mbtyRyEEADo

Manus:
elecraft_kx3.jpg
elecraft_kx3.jpg [ 127.42 KB | Vaadatud 6528 korda ]

KX3 STANDARD FEATURES
°160-6 meter ham bands; general coverage from 1.6-30 MHz (optional broadcast-band filter module covers 0.5-1.6 KHz)
°All modes: SSB, CW, Data (four sub-modes), AM FM
°Ultra-compact size: 3.4″H x 7.4″W x 1.7″D; 18 oz. (less options)
°Rear tilt feet fold up for transport
°Custom high-contrast LCD with alphanumeric text display
°Current drain as low as 150 mA in receive mode
°High-performance 32-bit floating-point DSP
°Built-in PSK/TTY decode/encode allows data mode operation without a PC; transmit in data modes using CW keyer paddle
°Low-noise synthesizer with 1-Hz tuning resolution
°Firmware updateable via provided application software

RECEIVER
°Quadrature down-sampling mixer compatible with PC-based SDR (software-defined-radio) applications
°Receiver I/Q outputs for use with PC soundcard
°Narrow roofing filter option with four bandwidths (500Hz, 1500Hz, 2700Hz,3800Hz) for excellent dynamic range
°Switchable preamp (2 levels) and attenuator (2 levels)
°8-band receive audio equalizer
°Dual watch over ?10kHz range; uses applicable roofing filter
°Easy-to-use PassBand Tuning (PBT) for shift/width/hicut/locut; roofing filters automatically track DSP filter settings
°Automatic and manual notch filtering; adjustable noise reduction and noise blanking; binaural audio effects for enhanced receive
°Center-tuning indicator for CW and data modes
°Built-in speaker; stereo jack for headphones/external speakers

TRANSMITTER
°Adjustable output, 0.1 to 10W+ (100W+ with KXPA100 amp)
°Ruged, SWR and temperature-protected final amplifier stage
°Optional MH3 microphone with PT and UP/DOWN functions
°Optional attached keyer paddle with spacing adjustment
°Switchable PA output impedance for efficient 5-W or 10-W use
°Fast, silent, PIN-diode T-R switching – no relays
°DSP speech processing for excellent “punch”
°8 band equalizer tailors passband to your voice and microphone

OTHER FEATURES
°Built in digital voice recorder (DVR) with two message buffers
°Internal CW keyer with 8-50 WPM range
°Six CW/DATA message memories
°100 general-purpose memories store VFO A/B, modes, etc.
°Accessory/RS-232 port for computer control using supplied cable
°Full remote-control command set works with most amateur radio software applications (emulates Elecraft K3)
°One-click firmware upgrades via the web (with free PC software)
°Optional mobile bracket compatible with RAM-mounts
°Tutorial-style manual ideal for new hams

OPTIONS and ACCESSORIES
°KXFLE Roofing Filter Module (500/1500/2700/3800 Hz)
°KXAT3 Internal, Wide-Range 20-W Automatic Antenna Tuner
°KXAM3 Broadcast Band Filter Module (0.5-1.6 MHz)
°KXBT3 Internal 8-AA Cell Battery Pack with NiMH Charger (Batteries not supplied; non-rechargeable batteries can also be used)
°KXPD3 Precision Keyer Paddle
°KXMM3 Mobile Mount Bracket
°MH3 Hand Microphone with UP/DN Controls
°KUSB RS232 to USB Adapter
°KXPA100 High-Performance 160-6 meter, 100-W Amplifier; usable with most 5 to 10 W transceivers
°KXAT100 Wide-Range 100-W ATU with Dual Antenna Jacks (attaches to KXPA100 module)

(from Elecraft reflector)

KX3: Ultra-compact K3/KX1 hybrid, 160-6 m, 10/100 W, all-mode, 32-bit DSP/SDR, 1.5 lbs.

Ultraportable:

■1.5 lbs (680g)
■1.7″ x 3.5″ x 7.4″ (4.3cm x 8.9cm x 18.8cm)
■extended KX1 form-factor (KX1 - 1.2 x 3 x 5.3″ (3 x 7.5 x 13 cm) KX1 base weight 9oz / 255g)
■internal battery pack & charger
■internal wide-range ATU
■new adjustable, attached keyer paddle
…and a K3-like front panel, including the same LCD.

RX-mode current drain ~150 mA. Very efficient on TX, with dual-output-impedance 5W/10W PA.

The optional 100W amp is in an external chassis. The internal amplifier is 10W with switchable impedance matching so it can also operate with maximum efficiency at 5W.

PA output impedance switch allows efficient 5-W use from internal batteries, or 10 W from external supply.

KXPA100 - 100 W+ with new high-performance external amp/ATU that works with most 5W to 10W rigs.

>Same flat layout as the KX-1 – just bigger box I would assume????

Yes, but with new fold-up rear tilt-feet.

>…and a K3-like front panel, including the same LCD.
>
> And it makes use of EVERY display on that LCD?? Carumba!

Not quite. I think there are a couple annunciators that are not used. But it’s amazing that the design team managed to fit almost all the features of a 10W K3 into a box that is a small fraction of the size and weight. And with space left over for an internal battery pack!

By the time we’re done, we’ll be using every icon.

Totally different architecture than the K3, of course. (Wayne N6KR)

RX-mode current drain ~150 mA. Very efficient on TX, with dual-output-impedance 5W/10W PA.

> Dual output impedance 5w/10w pa? I don’t understand.

The MOSFET 10-W amp stage includes an output transformer with both 1:4 and 1:1 windings. When using low power, or when running from internal batteries, the 1:1 winding is used, which optimizes efficiency at about 5 W, greatly reducing transmit current drain. The 1:4 winding is used when running higher power (using an external supply).

> One email said 10w/100w models. Is that correct?

The 1.5-pound radio itself puts out 10 watts+. We’ll also be describing a new, high-performance 100-watt+ companion amplifier/ATU for fixed-station/mobile use. It will work very well with other 5 to 10-W radios besides the KX3.

_________________
Parimatega,
ES2ADF alias Pauhh
http://pauhh.planet.ee/adf


Üles
 Profiil  
 
 Teema pealkiri: Re: QRP rigi Elecraft KX3
PostitusPostitatud: 09 Juun 2011, 14:28 
Eemal
Kasutaja avatar

Liitunud: 23 Aug 2009, 20:29
Postitusi: 775
Asukoht: Taebla KO18UW
Rohkem infi: http://www.elecraft.com/KX3/kx3.htm
Tundub, et panen oma 706 turgu :wink:

_________________
Parimatega,
ES2ADF alias Pauhh
http://pauhh.planet.ee/adf


Üles
 Profiil  
 
 Teema pealkiri: Re: QRP rigi Elecraft KX3
PostitusPostitatud: 21 Juun 2011, 13:48 
Eemal
Kasutaja avatar

Liitunud: 29 Nov 2005, 17:12
Postitusi: 135
pauhh kirjutas:
Rohkem infi: http://www.elecraft.com/KX3/kx3.htm
Tundub, et panen oma 706 turgu :wink:


Tundub väga hea idee.

73,
Riho, ES7AAZ.


Üles
 Profiil  
 
 Teema pealkiri: Re: QRP rigi Elecraft KX3
PostitusPostitatud: 21 Juun 2011, 16:28 
Eemal
Kasutaja avatar

Liitunud: 01 Dets 2005, 09:12
Postitusi: 1347
Asukoht: KO28TI
es7aaz kirjutas:
pauhh kirjutas:
Rohkem infi: http://www.elecraft.com/KX3/kx3.htm
Tundub, et panen oma 706 turgu :wink:


Tundub väga hea idee.

73,
Riho, ES7AAZ.


Kumb?


Üles
 Profiil  
 
 Teema pealkiri: Re: QRP rigi Elecraft KX3
PostitusPostitatud: 21 Juun 2011, 17:17 
Eemal
Kasutaja avatar

Liitunud: 29 Nov 2005, 17:12
Postitusi: 135
ES7GN kirjutas:
es7aaz kirjutas:
pauhh kirjutas:
Rohkem infi: http://www.elecraft.com/KX3/kx3.htm
Tundub, et panen oma 706 turgu :wink:


Tundub väga hea idee.

73,
Riho, ES7AAZ.


Kumb?


IC-706 vahetamine Elecraft KX3 vastu.


Üles
 Profiil  
 
 Teema pealkiri: Re: QRP rigi Elecraft KX3
PostitusPostitatud: 05 Apr 2012, 15:29 
Eemal
Kasutaja avatar

Liitunud: 23 Aug 2009, 20:29
Postitusi: 775
Asukoht: Taebla KO18UW
No nii, müügis! Kas on keegi juba tellinud või siis plaan seda teha?
Esimene paisati müüki 29.03 nii, et kas oleme esimeste seas!? :wink:
http://www.elecraft.com/elecraft_prod_list.htm#kx3

_________________
Parimatega,
ES2ADF alias Pauhh
http://pauhh.planet.ee/adf


Üles
 Profiil  
 
Näita postitusi eelmisest:  Sorteeri  
Tee uus teema Vasta teemale  [ 6 postitust ] 

Kõik kellaajad on UTC + 1 tund [ DST ]


Kes on foorumil

Kasutajad foorumit lugemas: Registreeritud kasutajaid pole ja 2 külalist


Sa ei saa teha uusi teemasid siin foorumis
Sa ei saa postitustele vastata siin foorumis
Sa ei saa muuta oma postitusi siin foorumis
Sa ei saa kustutada oma postitusi siin foorumis
Sa ei saa postitada siin foorumis manuseid

Otsi...:
Hüppa:  
POWERED_BY
et 3.0.10